Inventory check. Make sure you have everything
before you begin.
Pellets (2,000mg�s make 76mg/20ml)
3-5 cc syringe
Two needle tips
3 vials, one with solution, one with oil, one empty (sterile) vial
Alcohol or alcohol wipes
Gloves (plastic bags) Places to get the items need for your conversions
Crush pellets with an alcohol wiped spoon, in a
alcohol wiped dish, jar, glass etc. Crush them finely. The finer
the pellets are crushed, the less time they take to dissolve in
Put a funnel into the vial with lesser
amount solution, (clear solution), and pour the crushed
pellets down the alcohol wiped funnel.
Let the solution sit, swirling it once every
minute, until the pellets have completely dissolved. (depending on
how well you crushed the pellets, this could take from 20min �
While the pellets are dissolving, get out a 3 to 5
CC syringe, and draw up 2 � 3 CC�s of oil and recap the
syringe and put it away. You will need this (2cc�s) for one of
the last steps in this process. (Note: get two cc�s from the oil
vial, darker solution, not the vial with the dissolving pellets,
but from the unused oil vial)
Once the pellets are COMPLETELY dissolved, pour the
oil from the vial you drew out 2cc�s oil into the vial with now
dissolved pellets. (Add oil from oil vial to dissolving pellets
Swirl the oil/solution/dissolved pellets mixture for 5
� 15 minutes or until it is completely MIXED.
Get the now emptied oil vial (the one you used to
pour oil into the pellet/solution vial) and place the funnel into
it, then, place the opened coffee filter into the funnel.
Then pour the oil/pellets/solution that has now
mixed well, down into the coffee filter slowly. Let it sit over
night and drip into the vial.
In the morning. Gently squeeze out any remaining
oil in the filter and let it drip down the funnel. then remove the
filter and funnel.
This is a picture of the coffee filter. discard all
of the gunk the filter caught.
Wipe top of the empty (so far unused,
sterile vial) vial with alcohol, and insert a needle tip to
release pressure when adding the final product.
Use at least a ten CC syringe and draw out
�oil/pellet/solution� mix into the syringe.
Remove the needle tip. Place a filter and needle
tip on the filled syringe, and filter the syringe contents into
the sterile vial. Continue this step until all the �mixed
solution� is into the sterile vial.
Then, put the filter on the needle with the saved
2cc�s (from the oil you saved earlier waiting for the pellets to
dissolve) and insert the needle in the sterile vial and run the
oil through the filter releasing any trapped �product.
the needle and needle tip, and you now have 20ml of sterile ready
to use Trenbolone acetate.
If you use an article from this site, Please consider a link back to WWW.BASSKILLERONLINE.COM if possible.. Thank you kindly