Conversion: Water Based Winstrol or Testosterone
Take some distilled water, and add 2% BA. (10mls of water to 2/10 ml of BA - the BA amount is so minute that it will not effect the total in this case)
Add a surfactant to the water (polysorbate 80 and Carboxymethylcellulose both work well for this), and mix thoroughly.
Now take 7ml's of this, and run it through a .2um sterile syringe filter, into a sterile 10ml vial. Remove the filter, and needles from the vial for now. You now have 7ml's of sterile water containing surfactant.
Now take 1 gram of either test base, or winny powder, and put it in a vial with 2 ml's super solvent(guaiacol). Heat it until it is completely dissolved.
Allow it to cool slightly, and draw it up in a 3cc syringe......now run this through a .45 sterile syringe filter, into the vial that contains the sterile water/surfactant.
Remove the filter and needles from the vial, and shake it up.
The testosterone base/winny will precipitate out in the water, but it has been micronized by running it through the filter, so this can easily be injected using a 25g needle.
This gives you a nice water based suspension......no clumps, no crystals.
Actually, you could also do this with your winny, and take it orally, and you wouldn't have the nasty everclear taste.
If you use an article from this site, Please consider a link back to WWW.BASSKILLERONLINE.COM if possible.. Thank you kindly
Come join us at the hottest Bodybuilding steroid board around
Free to join!!!!
World class bodybuilding